Device Button Functions
 |  |
QUICK Press - 1 second
Center button press is signified by paired
beep and flash at 1 second
Sensor and Valve Controller
- Test for power by verifying the single beep and indicator light.
- When device is in alarm this function will silence the device. Device will then be in a 30 minute (variable default) lockout period. See Medium Hold to bypass lockout.
MEDIUM Hold - 12 seconds
Center button Hold is signified by paired beep
and flash at 0, 12 seconds
Sensor and Valve Controller
- When in normal operating mode, this function will re-register the device.
- When in a silence mode (after responding to a water alarm), this function will bypass (manual reset) the lockout period and set the device back to normal operation.
LONG Hold - 20 seconds
Center button Hold is signified by paired beep
and flash at 0, 10 and 20 seconds
Sensor and Valve Controller
- This function will enter Test Mode for the next 120 seconds (2 minutes). All alarms during the test period WILL NOT produce alarm notifications, however the alarm event timeline will be tracked and flagged as a Test Alarm within the Trident Platform.
Valve Controller Open & Close Button
A quick press of the open or close button
will drive valve 1 first (top connection), then valve 2 (if applicable).
See Also
Device Lock Out
Test Mode
Related Articles
Re-register a Device
A manual re-registration may need to be performed if a device has lost communication. Hub Hubs can be re-registered by removing the rubber cover on the bottom of the hub and gently pressing the left button, within the device, with a small tool. The ...Endpoint Test Mode
An endpoint (sensor or valve controller) can be placed into a test mode by following the steps below. This allows end users to audit and test the functionality of their Trident system on a regular basis. Place the endpoint into "test mode" by ...Valve Controller Installation & Commissioning
If you are replacing a Valve Controller, please use this solution article link as there are a few additional steps to follow. Replacing a Valve Controller If you are installing a new valve controller, the following steps within the Trident Platform ...DT-503 Trident Valve Controller Data Sheet
The DT-503 Trident Valve Controller is one of several endpoints TDG offers. The valve controller can act as a sensor with the 2 probes resting on a surface and control up to 2 STOPflow valves through our cloud valve groups. Valves are connected via a ...NEW! Trident Installation & Operation Manual
The Trident Installation and Operation Manual is a complete .pdf that covers the installation, operating, Trident configuration, and troubleshooting of the Trident System. The manual can be downloaded in the attachment section below. See Also Trident ...